10
C
HAPTER
1: I
NSTALLING
THE
I
NTELLI
J
ACK
Using the 3Com Local Power Supply
If your network does not support Power Over Ethernet, or if you are not using a
single-port or multi-port endspan power supply, you must purchase a local power
supply from 3Com. See"Obtaining Optional Components."
To power the IntelliJack with a local power supply, make sure you have an
electrical outlet near the site where the IntelliJack will be installed.
To connect the local power supply to the IntelliJack, follow these steps (as shown
in the previous diagram):
1
Route the power cable through the strain relief on the top of the IntelliJack.
2
Plug the power cable into the IntelliJack.
3
Check to ensure that the cable is secure in the strain relief.
4
Route the cable behind the trim ring from top to bottom.
5
Secure the local power supply and cable to the wall.
6
Plug the local power supply into the power source.
CAUTION: Use only a power supply that is provided or approved by 3Com for
use with this IntelliJack. Failure to do so may result in damage to the IntelliJack,
or may result in a hazardous situation or personal injury.
Содержание IntelliJack NJ225FX
