2N SingleTalk, Руководство пользователя

Страница: 48 / 73

2N® SingleTalk Programming
3.1
47
Tip

To check programmed values : enter parameter number and , listen
the parameter value and press for return to the main menu.
Caution

Unfortunately, some telephone sets become “mute” for a second after
sending the DTMF signal. Try to use another telephone in this case.
Programming Error

If you make an error while entering a number (whether a wrong function
number or value) and you recognise it before entering an asterisk, push to
cancel the number and enter a new one.

If the ST rejects the selected parameter number or value, the programming
procedure can continue – the function number must be re-entered even if only
the value was wrong.

If you program a false value and it gets stored, you can re-enter the value of
course.
Programming Termination

Having stored all values you needed to change, terminate programming by
pressing . The ST sends a hang-up signal and hangs up.

If you do not use , the ST hangs up later without influencing your storage
(the values are stored immediately upon entering).

In doubts, make sure that the programmed ST behaves according to your
assumptions.

Keep the filled-in programming form on a safe place.