Installation Guide for the 2GIG EDGE Security Panel
14
Install Jumper
1 .
Carefully disconnect the existing wire from the terminal location where one side of the Jumper will be connected.
2 .
Connect the Jumper Wire from the vacated terminal to the vacant Jumper terminal adjacent to the Antenna Terminal. The jumper wire
should snap into place on each terminal.
3 .
Insert the exposed wire from Step 1 into the available foam holder to isolate it from exposure to other board components.
Terminal
Exising Wire Disconnected
Jumper Terminal
Jumper
Terminal
Antenna
Terminal
Jumper Wire
Insert
Wire