![background image](http://html.mh-extra.com/html/sealey/cst01/cst01_instructions_1226904001.webp)
INSTRUCTIONS FOR:
CYCLE STORAGE TENT
MODEL NO:
CST01
WARNING!
Ensure Health & Safety and local authority practice regulations are adhered to when using this equipment.
Familiarise yourself with the specific applications and limitations of the shelter, as well as any potential hazards.
DO NOT
use the shelter for any purpose other than that for which it is designed.
Maintain correct balance and footing. Ensure the floor/ground is not slippery and wear non-slip shoes.
Locate the shelter on level and solid ground. If placed on grass ensure that the cycle is adequately supported before using the shelter.
Locate the shelter in a suitable area. Keep the area clean and tidy and free from unrelated materials, and ensure that there is adequate
lighting.
DO NOT
use if any parts are damaged, as this may cause failure and/or personal injury.
DO NOT
use the shelter when you are tired or under the influence of alcohol, drugs or intoxicating medication.
Keep children and unauthorised persons away from the working area.
Keep the shelter clean for best and safest performance.
1. SAfETY
2. INTRODuCTION
3. SpECIfICATION
4. ASSEmbLY
Versatile and innovative low cost solution to bike storage for home and workplace. Can be secured to a solid structure or free standing. Water
resistant and large enough for 2-3 adult sized bikes and other items such as lawn mowers. Extra security is provided by a small access panel at
the rear of the tent to allow the contents to be secured to fixing points by chain or bike cable. Manufactured from polyester and polyurethane.
Approximate Size: . . . . . . . . . . . . . . 2000 x 800 x 1670mm
4.1.
Remove tent from bag, unroll and lay on ground, with ground sheet side facing down.
4.2.
Extend both long poles to their full length.
4.3.
Slide poles into the sleeves that run the length of each side of the tent. Fix the ends of the poles into the holes in the tabs at each of the
four corners, (see fig.1).
4.4.
Extend the seven cross poles and place their ends into the eyelets around the circumference to tension the width of the tent, (see fig.2).
4.5.
Position the tent in its final location and anchor it through the corner tabs using the tent pegs, (see fig.1).
4.6.
Use the eyelets around the circumference to attach guy ropes (not supplied) for extra stability in windy weather.
fig.2
fig.1
Original Language Version
© Jack Sealey Limited
CST01 Issue: 1 - 24/03/14
IMPORTANT:
pLEASE READ THESE INSTRuCTIONS CAREfuLLY. NOTE THE SAfE OpERATIONAL REQuIREmENTS, WARNINGS & CAuTIONS. uSE THE
pRODuCT CORRECTLY AND WITH CARE fOR THE puRpOSE fOR WHICH IT IS INTENDED. fAILuRE TO DO SO mAY CAuSE DAmAGE AND/OR
pERSONAL INJuRY AND WILL INVALIDATE THE WARRANTY. KEEp THESE INSTRuCTIONS SAfE fOR fuTuRE uSE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.