background image

1-

With the tailgate open, place the tent in your truck bed 

with the no-see-um mesh side facing up. Slip the tailgate 

pockets over the end of the tailgate and run the tailgate 

strap underneath.

3-

Attach the (2) black strap clips to the bottom outside 

lip of the truck bed (Fig 3) and (1) black strap clip to the 

wheel well (Fig 4). Repeat on the opposite side of the 

truck bed. 

5-

Tilt the tailgate up, resting it against your body (Fig 8). 

Thread the orange straps through the gap between the 

tailgate and the truck bed (Fig 9). 

Truck Tent Set Up Guide

8-

Each of the (3) tent poles is marked with colored tape 

near one end of the pole (2 orange and 1 gray) (Fig 14). 

Run all (3) tent poles through their matching color pole 

sleeves (Fig 15). The gray marked rear pole will run under 

the (2) orange marked dome poles. 

Fig 1

Fig 2

6-

Release the tailgate down. The round part of the strap’s 

clips will be held in place against the underside of the 

tailgate (Fig 10). You may alternatively fasten the clips to 

a metal frame member behind the truck’s bumper (Fig 11). 

Set Up The Truck Tent

2-

Pull the tent forward so that it covers the entire truck bed 

(Fig 1). The front corners of the tent have split seams that 

go over cab-wrapping bed curves (Fig 2).

Fig 3

Fig 4

Fig 5

Fig 6

Fig 8

9-

Raise the (2) orange marked dome poles after inserting 

their ends into their matching color pole pockets (Fig 16). 

Raise the gray marked rear pole by the same method.

10-

Attach the (4) black pole clips to the rear gray marked 

pole (Fig 17) and adjust all straps as necessary.

Fig 9

Fig 10

Fig 11

Fig 12

Fig 14

Fig 13

Fig 7

Fig 15

4-

Tighten the tailgate strap (Fig 5) before running the 

black strap clip from the tailgate flap over the rear side 

strap and attaching it to the bottom outside lip of the truck 

bed (Fig 6). Repeat on the opposite side of the truck bed. 

Snug up the straps, keeping the inner flap seam even with 

the top of the bed rail (Fig 7).

7-

Position  the  inner  side  flap  under  the  orange  straps 

and pull out the slack (Fig 12). Tighten the orange straps, 

keeping the inner flap seam even with the top of the bed 

rail (Fig 13).

Fig 16

Fig 17

Reviews: