YOLI PRO 100 SET UP INSTRUCTION
SECURING THE CANOPY TOP TO THE FRAME
SET UP
THANK YOU FOR PURCHASING A YOLI INSTANT CANOPY!
Please carefully review the following instructions and familiarize yourself with parts included
and how to operate your YOLI canopy. Reference parts list for names of each part noted in instructions.
Parts Included:
Fully Assembled Frame (1) Canopy Top (1) Carry Bag (1) Stakes (4)
Place the canopy frame in the desired location (
Fig. 1A
).
With partner, stand opposite side of the frame and hold the outer legs.
1
While holding the legs lift slightly off the ground taking a few steps backwards
to extend frame at full arm’s length as shown (
Fig. 2A
).
2
Unfold the canopy top and place it over the open frame (
Fig. 3A
). Locate in the center of the eaves frame where
it forms a diamond shape a large slotted fastener as pictured in (
Fig. 3B
). Remove the fastener using a coin or screw
driver (if needed). Pull the canopy top over the eaves where the canopy grommet meets the screw head as pictured
in (
Fig. 3D
). Tighten the large slotted fastener to the screw head to secure the canopy top as pictured in (
Fig. 3E
).
3
Secure each corner by attaching the corner of the canopy top to the black fastening strip (
Fig. 4A
).
Pull all 4 corners down until completely over black fastening strip. Your canopy top is now secured to the frame.
4
Place the canopy in the desired location for shade. With partner standing on the opposite side of the canopy,
hold the outer legs and lift slightly off the ground stepping backwards (
Fig. 1A
).
1
With partner hold the top and bottom of the middle of the eaves where it makes a diamond shape as
pictured in (
Fig. 2A
) lifting slightly off the ground walking backward to extend the frame.
Be careful not to pinch your fingers as the frame opens!
2
At the top of the leg, place one hand on the top corner pushing down and with the other hand just below the
latch slider lifting up until it locks into position as pictured in (
Fig. 3A
). Repeat on other 3 legs.
3
4
1A
Fig.
3A
Fig.
3B
Fig.
3D
Fig.
3E
Fig.
4A
Fig.
2A
Fig.
1A
Fig.
3A
Fig.
4A
Fig.
2A
Fig.
With partner standing on the same side, lift outer leg to slide out inner leg until the push button
clicks into place at desired height as shown (
Fig. 4A
). Repeat on opposite legs.
