ZyXEL Communications WRE6505 v2, User Manual

Page: 11 / 132

Chapter 1 Introduction
WRE6505 v2 User’s Guide
11
The following table describes the LEDs.
1.4 WPS Button
The WPS button can be used to begin Wi-Fi Protected Setup (WPS), reboot the WRE6505 v2 while
keeping it’s configuration or reboot the WRE6505 v2 to factory default configuration.
Table 1
Front Panel LEDs
LED COLOR STATUS DESCRIPTION
Power/WPS Blue On The WRE6505 v2 is receiving power and functioning properly.
Blinking The WRE6505 v2 is booting, resetting to factory defaults, the
WRE6505 v2 is waiting for another WPS device to connect, or
firmware upgrade is in progress.
Off The WRE6505 v2 is not receiving power, or there is no WPS
connection established.
2.4 GHz Signal
Strength White On The more the LEDs are on the better the Wi-Fi signal strength.
• Three LEDs: signifies a signal strength of 51% ~ 100%
• Two LEDs: signifies a signal strength of 20% ~ 50%
• One LED: signifies a signal strength under 20%
Blinking Firmware upgrade is in progress.
Off The 2.4 GHz wireless LAN is not enabled, there is no signal
detected or the WRE6505 v2 (repeater mode) is not connected
to a wireless router/AP, or the LEDs are turned off using the
WPS button.
5 GHz Signal
Strength White On The more the LEDs are on the better the Wi-Fi signal strength.
• Three LEDs: signifies a signal strength of 51% ~ 100%
• Two LEDs: signifies a signal strength of 20% ~ 50%
• One LED: signifies a signal strength under 20%
Blinking Firmware upgrade is in progress.
Off The 5 GHz wireless LAN is not enabled, there is no signal
detected or the WRE6505 v2 (repeater mode) is not connected
to a wireless router/AP, or the LEDs are turned off using the
WPS button.
Table 2
WPS Button Functions
ACTION RESULT
Press thress times within
5 seconds Turn off or turn on all LEDs.
AP Mode
Push twice within 5
seconds The WRE6505 v2 begins connecting to a wireless client via WPS. See Section 1.4.1
on page 12 .
Hold for 5 to 10 seconds The WRE6505 v2 keeps its configuration and reboots.
Hold for more than 10
seconds The WRE6505 v2 resets its configuration to factory defaults and reboots. See
Section 2.4 on page 18 .
Repeater Mode
Push twice within 5
seconds The WRE6505 v2 begins connecting to a wireless client via WPS. See Section 1.4.1
on page 12 .