Chapter 1 Introducing the VMG
VMG3925-B10C/B30C User’s Guide
25
Figure 10
VMG3925-B10C/B30C Rear Panel
The following table describes the items on the rear panel.
1.4.6 The RESET Button
If you forget your password or cannot access the Web Configurator, you will need to use the
RESET
button at the back of the device to reload the factory-default configuration file. This means that you will
lose all configurations that you had previously and the password will be reset to the factory default (see
the device label).
1
Make sure the
PWR/SYS
LED is on (not blinking).
2
To set the device back to the factory default settings, press the
RESET
button for more than five seconds
or until the
PWR/SYS
LED begins to blink and then release it. When the
PWR/SYS
LED begins to blink, the
defaults have been restored and the device restarts.
Rear Panel Ports
LABEL
DESCRIPTION
DSL
Connect a RJ-11 cable to the DSL port for Internet access.
LAN1 ~ LAN4 Connect computers or other Ethernet devices to Ethernet ports for Internet
access.
WAN
Connect an Ethernet cable to the Ethernet WAN port for Internet access.
Power
Connect the power cable and press the power button to start the VMG.
Reset
Press the button to return the VMG to the factory defaults.
Power
Button
Press the power button after the power cable is connected to start the
VMG.