ZyXEL Communications P-128IMH, User Manual, Page: 84 / 191

Prestige 128IMH ISDN Modem/ Router/Hub
5-2 Remote Node TCP/IP Configuration
5.1.1 Remote Node Setup
Follow the procedure in Chapter 5 - Remote Node Configuration to configure the protocol-
independent parameters in Menu 11 - Remote Node Profile. For the TCP/IP parameters, follow
the instructions below. If you are configuring your Prestige to receive incoming calls, you also
need to set the default dial-in parameters in Menu 13.
Follow the steps below to edit Menu 11.3 - Remote Node Network Layer Options shown below.
In Menu 11.1, make sure
IP
is among the protocols in the Route field. (The Route field should
display Route = IP or Route = IP + IPX.)
Move the cursor to the Edit IP/IPX/Bridge field, then press the space bar to toggle and set the
value to Yes . Press [Enter] to open Menu 11.3 - Network Layer Options.
Figure 5-2 Menu 11.3- Remote Node TCP/IP Options
Menu 11.3 - Remote Node Network Layer Options
IP Options:
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Single User Account= No
Metric= 2
Private= No
RIP Direction= Both
Version= RIP -2B
IPX Options:
Dial -On-Query= N/A
Rem LAN Net #= N/A
My WAN Net #= N/A
Hop Count= N/A
Tick Count= N/A
W/D Spoofing(min)= N/A
SAP/RIP Timeout(min)= N/A
Bridge Options:
Dial -On-Broadcast= N/A
Ethernet Addr Timeout(min)= N/A
Enter here to CONFIRM or ESC t o CANCEL: