ZyXEL Communications P-128IMH, User Manual, Page: 73 / 191

Prestige 128IMH ISDN Modem/ Router/Hub
Remote Node Configuration 4-1
Chapter 4
Remote Node Configuration
A remote node is required for placing calls to a remote gateway. A remote node represents both
the remote gateway and the network behind it across a WAN connection. Note that when you use
Menu 4 to set up Internet access, you are actually configuring one of the remote nodes. Once a
remote node is configured correctly, traffic to the remote network will trigger your Prestige to
make a call automatically, i.e., Dial On Demand.
In this chapter, we will discuss the parameters that are protocol independent. The protocol-
dependent configuration will be covered in subsequent chapters. For TCP/IP,
see
Chapter 5
, for
IPX, see
Chapter 6
and for Bridging, see
Chapter 7
.
4.1 Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
4.1.1 Remote Node Profile
To configure a remote node, follow these steps:
Step 1.
From the Main Menu, select menu option
1. Remote Node Setup
Step 2.
When Menu 11 appears, as shown below, enter the number of the remote node that you
wish to configure.