ZyXEL Communications MAX-200M1 Series, User Manual

Page: 80 / 258

ZyXEL MAX-200M1 Series User’s Guide
80 Chapter 7 WAN Setup
7.6 Configuring Traffic Redirect Settings
To change your ZyXEL Device’s traffic redirect settings, click Network > WAN > Traffic
Redirect . The screen appears as shown.
Figure 45 Network > WAN > Traffic Redirect
The following table describes the labels in this screen.
Allow between LAN
and WAN
Select this check box to forward NetBIOS packets from the LAN to the WAN
and from the WAN to the LAN. If your firewall is enabled with the default policy
set to block WAN to LAN traffic, you also need to enable the default WAN to
LAN firewall rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the
WAN and from the WAN to the LAN.
Allow Trigger Dial Select this option to allow NetBIOS packets to initiate calls.
Apply Click this button to save your settings.
Reset Click this button to return all the fields in this screen to their default values.
Table 18 Network > WAN > Advanced
LABEL DESCRIPTION
Table 19 Network > WAN > Traffic Redirect
LABEL DESCRIPTION
Traffic Redirect
Active Select this check box to have the ZyXEL Device use traffic redirect if the normal
WAN connection goes down.
Note: If you activate traffic redirect, you must configure the Check
WAN IP Address field.
Backup Gateway
IP Address
Type the IP address of your backup gateway in dotted decimal notation. The
ZyXEL Device automatically forwards traffic to this IP address if the ZyXEL
Device's Internet connection terminates.