ZyXEL Communications IES-1248-71, User Manual

Page: 258 / 464

Chapter 39 Alarm
IES-1248-71/73 User’s Guide
258
39.5 Alarm Port Setup Screen
Use this screen to set the alarm severity threshold for recording alarms on an individual
port(s). The system reports an alarm on a port if the alarm has a severity equal to or higher
than the port’s threshold.
To open this screen, click
Alarm , Alarm Port Setup .
Figure 133 Alarm Port Setup
The following table describes the labels in this screen.
Apply Click Apply to save your changes to the IES-1248’s volatile memory. The IES-
1248 loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Close Click Close to exit the screen without saving your changes.
Table 83 Alarm Event Setup Edit (continued)
LABEL DESCRIPTION
Table 84 Alarm Port Setup
LABEL DESCRIPTION
Alarm Status Click Alarm Status to go to a screen that displays the alarms that are currently
in the system (see Section 39.2 on page 253 ).
Alarm Event Setup Click Alarm Event Setup to go to a screen where you can configure the
severity level of an alarm(s) and where the system is to send the alarm(s). See
Section 39.4 on page 255 .
Port This column lists the device’s individual DSL and Ethernet interfaces.
Severity Select an alarm severity level (critical, major, minor or info) as the threshold for
recording alarms on this port. Critical alarms are the most severe, major alarms
are the second most severe, minor alarms are the third most severe and info
alarms are the least severe.
Apply Click Apply to save your changes to the IES-1248’s volatile memory. The IES-
1248 loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Cancel Click Cancel to start configuring the screen again.