ZyXEL Communications Dimension ES-3148, User Manual, Page: 246 / 282

Dimension ES-3148 User’s Guide
244 Chapter 33 IEEE 802.1Q Tagged VLAN Commands
33.2.2 Dynamic Entries (DVLAN Table)
Dynamic entries are learned by the switch and cannot be created or updated by administrators.
The switch learns this information by observing what port, source address and VLAN ID (or
VID) is associated with a frame. Entries are added and deleted using GARP VLAN
Registration Protocol (GVRP), where GARP is the Generic Attribute Registration Protocol.
33.3 Configuring Tagged VLAN
The following procedure shows you how to configure tagged VLAN.
1 Use the IEEE 802.1Q tagged VLAN commands to configure tagged VLAN for the
switch.
• Use the
vlan <vlan-id>
command to configure or create a VLAN on the switch. The
switch automatically enters the
config-vlan
mode.Use the
inactive
command to
deactivate the VLAN(s).
• Use the
interface port-channel <port-list> command
to enter the config-
interface mode to set the VLAN settings on a port, then use the
pvid <vlan-id>
command to set the VLAN ID you created for the port-list to that specific port in the
PVID table.
• Use the
exit
command when you are finished configuring the VLAN.
Example:
Figure 143 Tagged VLAN Configuration and Activation Example
2 Configure your management VLAN.
• Use the
vlan <vlan-id>
command to create a VLAN (VID 3 in this example) for
managing the switch, and the switch will activate the new management VLAN.
• Use the
inactive
command to disable the new management VLAN.
Example:
ras (config)# vlan 2000
ras (config-vlan)# name up1
ras (config-vlan)# fixed 10-12
ras (config-vlan)# no untagged 10-12
ras (config-vlan)# exit
ras (config)# interface port-channel 10-12
ras (config-interface)# pvid 2000
ras (config-interface)# exit