![background image](http://html1.mh-extra.com/html/zyxel-communications/atp200/atp200_user-manual_943710272.webp)
Chapter 9 Interfaces
ZyWALL ATP Series User’s Guide
272
Each field is described in the following table.
9.8.2 Bridge Add/Edit
This screen lets you configure IP address assignment, interface bandwidth parameters, DHCP settings,
and connectivity check for each bridge interface. To access this screen, click the
Add
or
Edit
icon in the
Bridge Summary
screen. The following screen appears.
Table 109 Configuration > Network > Interface > Bridge
LABEL
DESCRIPTION
Configuration / IPv6
Configuration
Use the
Configuration
section for IPv4 network settings. Use the
IPv6 Configuration
section
for IPv6 network settings if you connect your Zyxel Device to an IPv6 network. Both sections
have similar fields as described below.
Add
Click this to create a new entry.
Edit
Double-click an entry or select it and click
Edit
to open a screen where you can modify the
entry’s settings.
Remove
To remove an entry, select it and click
Remove
. The Zyxel Device confirms you want to
remove it before doing so.
Activate
To turn on an entry, select it and click
Activate
.
Inactivate
To turn off an entry, select it and click
Inactivate
.
Create Virtual
Interface
To open the screen where you can create a virtual interface, select an interface and click
Create Virtual Interface
.
References
Select an entry and click
References
to open a screen that shows which settings use the
entry. See
for an example.
#
This field is a sequential value, and it is not associated with any interface.
Status
This icon is lit when the entry is active and dimmed when the entry is inactive.
Name
This field displays the name of the interface.
IP Address
This field displays the current IP address of the interface. If the IP address is 0.0.0.0, the
interface does not have an IP address yet.
This screen also shows whether the IP address is a static IP address (
STATIC
) or dynamically
assigned (
DHCP
). IP addresses are always static in virtual interfaces.
Member
This field displays the Ethernet interfaces and VLAN interfaces in the bridge interface. It is
blank for virtual interfaces.
Apply
Click
Apply
to save your changes back to the Zyxel Device.
Reset
Click
Reset
to return the screen to its last-saved settings.