ZyXEL Communications AMG1302-T11C, User Manual

Page: 168 / 307

Chapter 15 Firewall
AMG1302-T11C User’s Guide
168
The following table describes the labels in this screen.
15.3 The Default Action Screen
Use this screen to set the default action that the firewall takes on packets that do not match any of
the firewall rules. Click
Security > Firewall > Default Action to display the following screen.
Figure 83
Security > Firewall > Default Action
The following table describes the labels in this screen.
Table 61
Security > Firewall > General
LABEL DESCRIPTION
High This setting blocks all traffic to and from the Internet. Only local network traffic and LAN to WAN
service (Telnet, FTP, HTTP, HTTPS, DNS, POP3, SMTP) is permitted.
Medium This is the recommended setting. It allows traffic to the Internet but blocks anyone from the
Internet from accessing any services on your local network.
Low This setting allows traffic to the Internet and also allows someone from the Internet to access
services on your local network. This would be used with Port Forwarding, Default Server.
Custom This setting allows the customer to create and edit individual firewall rules.
Firewall rules can be created in the Default Action screen ( Section 15.3 on page 168 ) and Rules
screen ( Section 15.4 on page 169 ).
Off This setting is not recommended. It disables firewall protection for your network and could
potentially expose your network to significant security risks. This option should only be used for
troubleshooting or if you intend using another firewall in conjunction with your ZyXEL router.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Table 62
Security > Firewall > Default Action
LABEL DESCRIPTION
Packet Direction This is the direction of travel of packets ( LAN to WAN , WAN to LAN ).
Firewall rules are grouped based on the direction of travel of packets to which they apply.
Default Action Use the drop-down list boxes to select the default action that the firewall is to take on
packets that are traveling in the selected direction and do not match any of the firewall
rules.
Select Drop to silently discard the packets without sending a TCP reset packet or an ICMP
destination-unreachable message to the sender.
Select Reject to deny the packets and send a TCP reset packet (for a TCP packet) or an
ICMP destination-unreachable message (for a UDP packet) to the sender.
Select Permit to allow the passage of the packets.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.