HD-4002DM User Guide and Install Manual
Page 8
STEP 8
: Local Save for each Encoder tab
Once all parameters are set you are required to do a Local Save on EACH Encoder Tab where changes were performed
IMPORTANT NOTE:
Ensure all Encoder changes
have been locally saved before
performing Step 9.
Note:
Local
Save function will
indicate the local
change made
Upload and Reboot after all changes have
been made and a Local Save performed
STEP 9:
Upload and Reboot
Once you have set all the encoder settings and performed a
Local Save
for each encoder
Select “Upload and Reboot”
after you have saved all your Local changes on each Tab. This function will upload and save all
parameters set in the Common, RF, and Encoder sections of the device.
We highly recommend you save your encoder configuration files. See Administration tab for how to back you device settings.
STEP 10:
Network Configuration Tab
Use the Network Setup Tab to configure the device’s IP address, Subnet Mask, Gateway, Enable/Disable DHCP, and set Host Name.
