User Manual
Chapter 3: Recording Configuration
Motion Detection (NVR)
To enable motion detection on a NVR you need to:
5. Go to Main Menu > Sys Setup > Motion Detection.
6. Channel No. You can select All for all channels, or select the specific channel you want to configure.
7. Tick Switch Linkage
8. Area Set, Click on Set, and use your mouse to select the whole area, so the whole area is cover by blue.
Right click mouse to exist. (This is a important step and many people forget to do or done wrong)
9. Tick on Buzzer on if you want to test if the motion is working or not. (If can turn it o
ff
later)
10. Tick on Record Channel.
11. Sensitivity you can set to highest, and you can lower it later if you want.
12. Click on save.
13. Now go to Main Menu > Sys Setup > Rec Setup
14. You will see 7 lines of time range, you can tick on ALL or Select a Day if you only want to change that
day
15. Click on the first Cog ICON on the right hand side of the first time range.
16. Select Record and Motion
17. Tick ALL under Use to. Or you can only select a particular channel.
18. Click on save.
19. Now you have setup Motion Recording.
Schedule (NVR)
1. Go to main Main Menu > Sys Setup > Rec Setup
2. You will see 7 lines of time range, you can tick on ALL or Select a Day if you only want to change that
day
3. Click on the first Cog ICON on the right hand side of the first time range.
4. Tick ALL under Use to. Or you can only select a particular channel.
5. Change the time range you want, you can setup 6 di
ff
erent schedule per day.
6. Select Record and Motion on the schedule you can changed.
7. Click on save.
8. Now you have setup Schedule Recording.
Motion Detection (IP Camera)
1.
Login to the web interface (Refer to Chapter 1 if you don’t know how to login to your IP Camera by web
interface)
2.
Click on Motion
3.
Click on the image for area selection. If an area is selected, if should be covered by red dotted square.
4.
Or you can simply select all.
5.
Change the sensitivity to meet your needs.
6.
Click on save
7.
Select on alarm section
8.
Tick on enable alarm and motion detection.
9.
Tick on Upload via SMTP if you want email alert.
Copyright: Domarsolutions Ltd
8
