34/52 | Operation manual Z130-SE | 05/2016
35/52 | Operation manual Z130-SE | 05/2016
10.2. Maintenance check list (prior to start of harvest) - master for copying
Machine no.: ZÜRN
Date:
Machine hours:
Comment
OK
1. Engine oil changed
2. Engine oil filter changed
3. Engine oil level checked
4. Hydraulic oil changed
5. Hydraulic oil filter changed
6. Hyd. tank vent filter changed
7. Hydraulic oil level checked
8. Air filter and safety cartridge changed
9. Coolant topped up
10. Coolant level checked
11. Coolant antifreeze checked
12. Fuel filter changed
13. Solenoid coil fitting on control block checked
14. Engine area checked for oiling and damage
15. Hydraulic hoses visually inspected
16. Rear axle lubricated
17. Tyre air pressure checked
18. Rear axle mounting on the chassis checked
19. Wheel nuts checked using 170 Nm (front)
20. Front axle bolts checked on the chassis
21. Tyre air pressure checked
22. Wheel nuts checked using 170 Nm (rear)
23. Belts checked for wear
24. Main drive belt
25. Variator belt
26. Variator adjustment chain checked
27. Drive belt turbine
28. Belt shaker drive
29. Belt straw chopper
30. Straw chopper lubricated
31. Threshing concave adjusted to 3 mm/checked
32. Covers fitted in side wall (2x small, 2x large)
33. Threshing concave fastening checked
34. Table locking pins firmly fastened
35. Table adjusting bolts firmly tightened (M10)
36. Turbine visual inspection
37. Shaker carrier lever pins firmly fastened
38. Shaker bolts 4x firmly fastened
39. Sieve and baffle plate firmly fastened
40. Sieve case carrier lever firmly fastened
41. Electrical connection to the joystick box
42. Chain for dust separator checked and lubricated
43. Feeding belt visual inspection
44. Main belt visual inspection
45. Table belt visual inspection
46.
Belt adjusting spindles firmly fastened (main, small, and table belt)
47. Belt drive on cereal table checked and lubricated
48. Table raising - lowering function checked
49. Reel raising - lowering function checked
50. Reel horizontal adjustment (if fitted)
51. Drive table knives checked
52. Blowing out changeover
53. Grain tank valve function checked
54. Joystick checked for correct function
55. Parking brake function checked
56. Reversing horn function checked
57. Inch pedal checked for correct function
58. Grain tank function (hydraulic)
59. Speed display (wind/threshing cylinder)
60. Variator adjustment checked for correct function
61. Lighting checked
Other comments:
Undertaken by:
ü
Ok
X Not Ok
O Not necessary
Not checked
