ZUG CombairSteamer V2000, Operating Instructions Manual

Page: 9 / 72

2 Using for the first time
Before operating the newly installed appliance for the first time, the following steps
should be taken:
▸ Remove packaging and transport materials as well as any protective blue film from
out of the cooking space.
▸ Remove all the accessories from out of the cooking space.
▸ Clean the cooking space.
▸ Long touch the display.
– The appliance starts.
– Various user settings necessary for operation appear in the display one after the
other.
▸ Make the settings and confirm.
▸ Fill the water tank up to the «max.» mark with fresh, cold drinking water and slot into
position in the water tank compartment.
▸ Start the rinsing of the water system.
If the rinsing is skipped, it must be carried out manually.
▸ Heat the empty cooking space to 100 °C for 5 minutes using the «Steam» ap-
plication.
– Wait 20 minutes until the appliance cools down and the water is pumped back.
▸ Empty the water tank and then fill with fresh water.
▸ Wipe down and dry the cooking space.
▸ Start the initial burn-in.
If the initial burn-in step is skipped, it must be carried out manually after completing
the initial set-up.
▸ Heat the empty cooking space (without wire shelves, baking trays, etc.) to 200 °C
for about 30 minutes using the application «Hot air».
Burning-in removes any oily residues in the cooking space. As there is likely to be
some smoke and odour given off, we recommend ventilating the room well during
this phase.
All temperatures in these operating instructions are given in degrees Celsius (°C).
9