65/71
User Manual for hybrid inverter HYD 10-20KTL-3PH - Rev. 1.0 of 25/08/2020
Identification: MD-AL-GI-00
Identification: MD-AL-GI-00
Rev. 4.0 of 31.01.18 - Application: GID
ID103
HwACOCP
Excessive AC hardware
output flows
ID110
Overload1
Overload protection 1
Check whether the inverter is running
in overload
ID111
Overload2
Overload protection 2
ID112
Overload3
Overload protection 3
ID113
OverTempDerating
Internal
temperature
too high.
Make sure that the inverter is
installed in a cool, well-ventilated
place, below the temperature limits
and away from direct sunlight. Check
that the inverter has been installed
according to the instructions in the
manual.
ID114
FreqDerating
AC frequency is too
high.
Make sure that the grid frequency
and voltage are within the acceptable
range
ID115
FreqLoading
AC frequency is too low
ID116
VoltDerating
AC voltage is too high
ID117
VoltLoading
AC voltage is too low
ID124
BatLowVoltageAlar
m
Low battery voltage
protection
Check that the battery voltage on the
inverter side is not too low
ID125
BatLowVoltageShut
Battery shutdown due
to low voltage
ID129
unrecoverHwAcOC
P
Permanent
hardware
error due to output
overcurrent
Internal inverter errors. Switch it off,
wait 5 minutes and switch it on again.
If the errors still occur, contact
technical support.
ID130
unrecoverBusOVP
Fixed bus overvoltage
error
ID131
unrecoverHwBusO
VP
Bus
hardware
overvoltage error
ID132
unrecoverIpvUnbal
ance
Permanent unbalanced
PV flow error
ID133
unrecoverEPSBatO
CP
Permanent
battery
overcurrent error in EPS
mode
ID134
unrecoverAcOCPIns
tant
Transient
battery
output
overcurrent
error
ID135
unrecoverIacUnbal
ance
Permanent unbalanced
output current error
ID137
unrecoverPvConfig
Error
Permanent
error
in
input mode settings
Check the mode of the PV input
(parallel/independent); if they are
not correct, change them.
ID138
unrecoverPVOCPIn
Permanent
input
