17/71
User Manual for hybrid inverter HYD 10-20KTL-3PH - Rev. 1.0 of 25/08/2020
Identification: MD-AL-GI-00
Identification: MD-AL-GI-00
Rev. 4.0 of 31.01.18 - Application: GID
Figure 7 - Correct positioning of the inverter (2)
3.6.
Assembly instructions
To remove the inverter, open the packaging, insert your hands into the slots on both sides of the
inverter and grasp the handles; lift the inverter out of the packaging and move it to the installation
position.
The inverter is quite heavy, so make sure to keep your balance while moving
it. Two or more people are needed to move the packaging and inverter.
Danger
When placing the inverter on the floor, place foam or paper under it to protect
the housing.
Attention
1.
Determine the position of the holes, make sure the positions of the holes are level, then mark
them with a marker pen. Use the drill to make the holes on the wall. The drill must remain
perpendicular to the wall. Try not shake it while drilling the holes so as not to damage the wall. If
the holes are not level, they must be repositioned and drilled again.
2.
Insert the expansion bolt vertically into the hole, pay attention to the insertion depth (it should be
sufficiently deep).
3.
Align the bracket with the hole, and secure it by tightening the expansion bolts with nuts.
