Zubler VARIO PRESS 300, Operation Instructions Manual

Page: 20 / 49

20
Page
➌
The Special Program
(Firing Program with two heeting rates, e.g. crystallization for IPS e.max
®
CAD)
Start temperature Temperature in the firing chamber at which the program starts.
Pre-dry Selecting “YES” activates the special pre-drying program.
Pre-dry time
Enter a time. In this section, the lift identifies a predefined position for the entire time, depending on the heat
radiated by the firing chamber. The object can thus be pre-dried at a constant temperature.
Closing time Time in which the lift moves in 10 increments into the firing chamber.
Soak temperature At this temperature, the object remains in the closed firing chamber in order to achieve an even temperature
distribution.
Soak time States the retention period of the object in the firing chamber before evacuation and the temperature increase.
Heat rate 1
Temperature increase per minute in order to reach the final temperature 1.
Final temperature 1 Temperature 1 at which the ceramic is sintered.
Hold time 1 Period for which the ceramic is maintained at the final temperature 1.
Heat rate 2 Temperature increase per minute in order to reach the final temperature 2.
Final temperature 2
Temperature 2 at which the ceramic is sintered.
Hold time 2 Period for which the ceramic is maintained at the final temperature 2.
Open temperature
Temperature at which the device opens the firing chamber.
Opening time Decent time of the lift from the chamber to the fully open position.
Vacuum Selecting “YES” activates the vacuum parameter (firing under vacuum).
Vacuum release During the heating up stage release Vacuum Heat up
During the hold time at final temperature release Vacuum Hold time
During the cooling stage release Vacuum Cooling
Vacuum end Display shows temperature at which the vacuum is released.
Edit done? Saving of the program.
IPS e.max ® is a registered Trademark of Ivoclar Vivadent
Main menu 1.