Zubler VARIO PRESS 300, Operation Instructions Manual

Page: 13 / 49

13
Page
Enter Esc Up
Down
2 - Pulse MC Ceramay
450°C Select program ...
40- PULSE MC OPAQUE 1+2
41- PULSE MC MARGIN 1
42- PULSE MC MARGIN 2
43- PULSE MC DENTIN 1
44- PULSE MC DENTIN 2
45- PULSE MC SHADE/STAIN
46- PULSE MC GLAZEFIRING
47- PULSE MC GLA.WITH P.
48-
49-
50- INTERFACE CORREC.1-5
51-
52-
53-
54-
55-
56- PULSE PTM 200/2
57- PULSE PTM 200/5
58- PULSE PTM 300/2
59- PULSE PTM 300/5
Program to run ...
27
Caution:
Close the furnace after completing
a firing or pressing!!!
1.1 Run Programs
Program start
■ After selecting "Run Program" from
the Main Menu and confirming this
selection with the green “Enter” key.
■ The Program Group is displayed. The
most recently activated program will
be highlighted. 19 other programs
addresses will also be displayed.
■ Each of the 500 programs (=25
brands with 20 programs each) can
be easily edited.
■ Depending on the ceramics or techni-
que used, it is always recommended
to allocate a complete block to one
brand or technique.
■
Use the dialer or +/- keys to highlight
the program you wish to run. Touch
the green “Enter” key to activate the
program.
■ To switch to another program group,
press the red "Esc" key and return to
the brand page (see page 15, “working
with the brand page”)
■ The operator using the furnace must
close the lift after completing the
firing or pressing program.
■ After closing the lift, the unit will remain
at the programmed idle temperature
for four hours. If the unit is not used,
it will automatically go into the stand-
by mode.
■ If, at the end of the program, the
chamber is not manually closed, the
device will automatically cool down to
the safety temperature of 400°C,
independent of the idle temperature
selected. Once this temperature has
been reached, the device will remain
in this state for 30 minutes.
At the end of this time, the device
will enter stand-by mode and close
automatically after the defined stand-
by temperature of 100°C has been
reached.
Main menu 1.