Zubler VARIO PRESS 300, Operation Instructions Manual

Page: 14 / 49

14
Page
Overwriting a program during
operation
Should you find that you have to tem-
porarily change one or more parameters
while a program is running, you can do
this by pressing the yellow “Edit Prog.”
key below the display.
In general, you can only change parame-
ters that have not already been started
when you press the key.
By pressing the “Edit” key, you activate
the edit mode. You can now change all
the parameters not yet processed in the
sequence of programs at the time of
modification, with regard to this individual
firing.
For this purpose there appears in the
display a red bar with the first modifiable
parameter. To adjust use the dialer or +/-
buttons.
Now confirm the changes with the green
“Enter” key to get to the next parameter.
The program sequence will be shown in
its usual form on the display.
The changes you have made are temporary
and apply only to the current firing cycle.
Editing can be carried out only once per
firing cycle.
Abort
Edit Prog
2 - PULSE MC CERAMAY
758C Run 43-PULSE MC DENTIN 1
-Pre dry 3:00
-Closing time 3:00
-Soak temp 450C
-Soak time 0:30
-Heat rate 55C
-Final temp 820C
-Hold time 1:00
-Opening time 1:00
758 C
740mm
2:44
Enter
Hold time 1:00
2 - PULSE MC CERAMAY
758C Run 43-PULSE MC DENTIN 1
-Pre dry 3:00
-Closing time 3:00
-Soak temp 450C
-Soak time 0:30
-Heat rate 55C
-Final temp 820C
-Hold time 1:00
-Opening time 1:00
760 C
740mm
2:43
Main menu 1.
en