26
Optional machine attachments
BACK
00012V40-GB-W
AR
TUNG FREIARM-FLACHBETTMASCHINEN_-_2022-09-27 - DC
Adjusting borer height
At the control, set the top shaft to 141° and adjust the clearance
between the borer point and stitch plate insert to 0.8 + 0.1 mm.
• Clean the stitch plate insert
e
and
place the 0.8 mm feeler gauge be
-
tween the borer and stitch plate insert.
• Slacken off the pressure screw
q
in
the borer holder and pull down the
borer
w
until it rests on the feeler
gauge.
• Tighten the pressure screw.
• Remove the feeler gauge.
Fig. 26:
Setting borer heights
Do not start operating the machine until the protective cover has been
correctly replaced.
0,8 + 0,1 mm (141°)
