Zoom X5V 1610, Quick Start Manual

Page: 9 / 32

9
3333
If the Encapsulation setting that you entered starts with
either PPPoE or PPPoA:
Click Write Settings to Flash and
Reboot and Confirm . Once the process is complete, the
X5V’s LINK light should remain on steady (this should take
about 15 seconds). If it doesn’t, go to the Troubleshooting
Tips on page 12.
If the Encapsulation setting that you entered starts with
either 1483 Bridged or 1483 Routed: You must check now to
make sure that your IP Addressing is correctly set. See Setting
IP Addressing on page 11.
4444
Go to your Web browser (i.e., Internet Explorer or Netscape
Navigator) and try to connect to a familiar Web address.
5555
If you connect successfully, your installation is complete
and you’re ready to browse the web!
Continue with Step 5:
Setting Up VoIP Service on page 13
If you do not connect successfully, refer to the
Troubleshooting Tips on page 12.
If You Do Not Have VPI, VCI, and
Encapsulation Settings from Your
Service Provider
If you do not have the settings from your service provider, the
tables beginning on page 26 show the settings for the most
commonly encountered service providers in the USA and many
other countries. If there is more than one setting for your service
provider, the most common is labeled (1), the next (2), and so on.
1111
Go to the Tables on page 26 and find your service provider
on the list. If you are in the USA and your service provider is
not on the list, follow the instructions using the settings for
Service Provider Not Shown at the bottom of the table.
2222
Now enter the corresponding VPI, VCI, and
Encapsulation settings
in the appropriate boxes in the Basic
Setup menu . The screen may change slightly, depending on