Getting
Connected
7
RT-323 rear
Getting
Connected
6
For mono playback, connect only the
[L/MONO OUT] jack. To selectively
use the output signal for certain
instrument sounds only, connect a
cable to the [SUB OUT 1/2] jack.
When a guitar or other instrument is connected to
the [LINE IN] jack, the sound from the instrument
is mixed with the sound of the RT-323 and output
from the [L/MONO/R OUT] jack.
To synchronize the RT-323 with an external
sequencer or to control the sound sources of
the RT-323 from an external MIDI component,
link the MIDI OUT connector of the equipment
with the [MIDI IN] connector on the RT-323.
To play an external MIDI component
from the RT-323, connect the [MIDI
OUT] connector of the RT-323 to the
MIDI IN connector of the external
component.
By connecting the optional foot pedal
FP01 or FP02 to the [CONTROL IN
1]/[CONTROL IN 2] jack, pitch, volume,
or sound can be controlled with the
pedal.
Connecting the optional foot switch
FS01 to the jack allows activating a
sound or switching the tone with your
foot.
Drum sound
source module
FP01/FP02
FS01
Headphones
Multi-effect
(ZOOM 505II etc.)
Guitar
LINE IN
L/MONO
OUT
R
OUT
PHONES
DC IN
CONTROL
IN 1
CONTROL
IN 2
SUB
OUT 1
SUB
OUT 2
MIDI
IN
MIDI
OUT
Bass
Mixer, audio system,
or other playback equipment
MIDI sequencer
(computer MIDI interface)
AC adapter
Getting Connected
The RT-323 can be powered from six IEC R6 (size AA) batteries. Follow the steps below to insert
the batteries.
After connections are established, check the sound by performing the following steps.
While the playback system is still turned off and the volume is fully turned down,
double-check whether all connections have been made correctly.
Turn power to the RT-323 on.
Connect the supplied AC adapter to the [DC IN] connector and set the [POWER] switch to
ON.
Turn power to the playback system on and adjust the volume.
While tapping a pad to produce sound, adjust the [OUTPUT] dial of the RT-323 and the
volume control on the playback system to a suitable position.
3
2
1
Using the Unit on Batteries
Preparations for Playback
Turn the unit over and open the battery
compartment cover.
1
Insert six fresh IEC R6 (size AA)
alkaline batteries.
2
Close the battery compartment cover.
3
If the LED lights up while the unit is powered from batteries, the batteries are exhausted.
Replace the batteries as soon as possible.
Six IEC R6 (size AA)
Summary of Contents for RhythmTrak RT-323
Page 1: ...OPERATION MANUAL...
