ZOODOS 48215, Instruction Manual

Page: 48 / 81

48
GB
Press the safety button (3). Press the on/off
button (2) on the handle (1) and allow the
mitre saw to reach full speed before starting
to cut the item.
The blade guard (5) will open automatically
when the blade (6) comes into contact with
the item.
Do not try to force the saw to either side.
Release the on/off button immediately if the
blade jams in the item.
Release the on/off button once sawing is
complete. Only lift the saw arm once the
blade has fully stopped.
Check that the blade guard closes when the
saw is lifted off the item.
Sawing with the telescopic extension
Loosen the lock knob for the telescopic
extension (18). Pull the saw arm out towards
you as far as possible. Start the saw as
described, and cut the workpiece from the
outside in. Release the on/off button once
sawing is complete. Only lift the saw arm
once the blade has fully stopped.
Replacing the saw blade
Disconnect the saw from the mains.
The saw arm must be locked and in the top
position. Secure the telescopic extension
with the lock knob (18).
Press the safety button (3) and push the
blade guard fully to the side.
Press the spindle lock (38) and turn the saw
blade until it locks securely. Remove the
lock screw (7) and outer flange by turning it
clockwise using the spanner supplied.
Do not dispose of the old blade in your
domestic refuse. Dispose of it correctly in
accordance with local guidelines.
Clean any filings and sawdust from the
spindle and lock screw.
Lubricate the lock screw with a drop of acid-
free oil.
Fit the new saw blade and the other parts in
the reverse order. Check that the direction
indicated on the saw blade matches the
direction of rotation of the motor. Turn the
saw blade manually to check that it does
not catch against any of the other parts
even when set for bevelling.
dt