10
、
GUARD BAR COMPONENT
93
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1244100-061000 ZT250 anti-water rubber of frame
2
2
1250105-018091 GB5789 M8×70
（
white zinc
）
2
3
1251700-058093
Flanging bushing φ8.2×φ11×4.5
＋
φ16×1.5
2
4
1240300-071000 Flanging bushing rubber
（
φ11×φ16×1
）
2
5
4044201-256051
ZT310
－
V Bumper decorative ball
（
Dark gray matte
）
2
6
1224100-037000 0 grade flame retardant cable tie (black 3.6×295)
2
7
1250201-032093 GB818M5×16 (environmental color)
2
8
1184200-177000 ZT310 electric jet ignition coil
1
9
1251100-101000 Non-standard bolt M6×12 (304 stainless steel)
1
Fig.1 GUARD BAR
COMPONENT
Guard bar assembly 1
PROCEDURE:
●
Bumper decorative ball
Remove the water stopper
⑴；
Using 12#sleeve remove the bolt
⑵，
the bushing
⑶
and buffer rubber
⑷
,
Remove the bumper decorative ball
⑸
.
Use the same method to remove the decorative ball on the left side.
Remove the left and right side covers and the fuel tank assembly by referring to the steps of removing the side
cover and the fuel tank assembly.
Pull out the two cable plugs of the rectifier. Cut the two straps
⑹
; Using cross screwdriver remove the two
bolts
⑺
and remove the ignition coil to expose the bolts
⑼
.
Using 4# inner hexagon socket remove the bolt
⑼
and move the ignition coil bracket and the oxygen sensor
wire back together to completely expose the bracket on the guard bar.
CAUTION:
●
The seat cushion, side cover, fuel tank asembly, etc. must be removed in advance.
●
When removing the high-pressure oil pipe, be sure to wait until the engine and muffler are completely cooled
before operating to prevent accidental ignition of the fuel and cause fire.
●
Fireworks, answering or dialing should be strictly prohibited near the car-breaking site to prevent accidents.
●
A small amount of fuel leakage is required when the high-pressure oil pipe sub-assembly is pulled out, and the
fuel should be prevented from dripping to the outside of the engine or the muffler.
