4
、
REAR WHELL COMPONENT
35
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1250104-006097 GB16674M6×12
（
chromed/HH
）
4
2
1274100-057095
Flanging bushing φ6.2×φ8.4×3.5
＋
φ14×1.5
5
3
1244100-052000 Buffer rubber of flanging bushing
（
φ8.5×φ14×1
）
5
4
1224200-201000 ZT310
－
VX rear mud board
1
5
1210342-449000 ZT310-X1 chain decal
1
6
1251100-101000 Non-standard bolt M6×12 (304 stainless steel)
1
PROCEDURE:
●
Rear mud board
Use 8# sleeve to remove bolt
⑴
on the upper right side, remove the bushing (2) and the cushion rubber (3).
Remove the bolt
⑹
on the lower right side with a 4# inner hexagon, and remove the bush
⑵
and the cushion
rubber
⑶
.
Using 8# sleeve remove the bolt (1) on the inside of the left inner side and remove the bushing (2) and the
cushion rubber (3).
Using 8# sleeve remove the bolt (1) at the rear left side and remove the bushing (2) and cushion rubber (3).
Hold the rear inner mud plate
⑷
, use an 8# sleeve to remove the bolt
⑴
on the upper middle of the left side,
and remove the bush
⑵
and the cushion rubber
⑶
.
The chain decal
⑸
can be heated back and forth by a hot air gun, and the applique is torn off from the inner
mud plate after the heat viscosity is lowered.
CAUTION:
●
When heating and tearing the applique, be careful not to align the same part for a long time to prevent damage
to the inner mud board.
●
The muffler assembly and lower shroud assembly must be removed in advance.
Fig.12 Rear wheel,
swinging arm component
Rear mud board
