ZOLL AutoPulse NXT, User Manual

Page: 78 / 85

Appendix C. Technical Specifications
AutoPulse NXT User Guide 73
The battery charger is intended for use in the electromagnetic environment specified below.
Immunity test IEC 60601 Test Level Compliance Level
Electromagnetic environment
guidance
Conducted RF
IEC 61000-4-6 3 Vrms 1 kHz
0.15 – 80 MHz 3 Vrms 1 kHz
0.15 – 80 MHz Portable and mobile RF communica -
tions equipment should be used no
closer to any part of the battery char
-
ger, including cables, than the rec -
ommended separation distance
calculated from the equation appli
-
cable to the frequency of the trans -
mitter.
Recommended separation distance
d = 1.17
√
P 0.15 to 80 MHz
d = 1.17
√
P 80 to 800 MHz
d = 2.3
√
P 800 MHz to 2.7 GHz
Where P is the maximum output
power rating of the transmitter in
watts (W) according to the transmit
-
ter manufacturer and d is the recom -
mended separation distance in
meters (m).
Field strengths from fixed RF trans
-
mitters, as determined by an electro -
magnetic site survey,
1
should be less
than the compliance level in each
frequency range.
2
Interference may occur in the vicinity
of equipment marked with the fol
-
lowing symbol:
1. Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios,
amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the
electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey should be considered. If the mea
-
sured field strength in the location in which the battery charger is used exceeds the applicable RF compliance level above, the
battery charger should be observed to verify normal operation. If abnormal performance is observed, additional measures
may be necessary, such as re-orienting or relocating the battery charger.
2. Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
Radiated RF
IEC 61000-4-3
3 V/m
80 MHz to 2.7 GHz
6 V/m in ISM bands
3
Spot frequencies
385 MHz – 5.750 GHz
Pulse Modulation
3 V/m
80 MHz to 2.7 GHz
6 V/m in ISM bands
3.
Spot frequencies
385 MHz – 5.750
GHz Pulse Modula
-
tion
Note 1: At 80 MHz and 800 MHz, the higher frequency range applies.
Note 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorp
-
tion and reflection from structures, objects, and people.
Table C.9: Guidance and manufacturer’s declaration – electromagnetic immunity for the battery charger