© Copyright 2002 Zoeller Co. All rights reserved.
5
7. Select installation location in the water line ahead of the water heater, close to a
drain and a 115 volt grounded outlet on a flat surface. NOTE: Make sure electric
outlet is grounded and cannot be turned off by a switch or a pull chain. Photo shows
typical finished installation.
8. Remove the brine tank cover.
9. Position softener near the main water supply line, a drain, and an electrical outlet.
Position so that main water supply shut off valve is between the softener and the
main water source. NOTE: Install unit in an area protected from the elements and
freezing.
10. Close the main water supply shut-off valve.
11. Open nearest water faucet to relieve pressure and drain plumbing lines.
12. On a new installation not already plumbed for a water softener, cut out section of
main water supply line downstream from the supply shut-off, at position softener is
to be installed.
Flow
