Figure 13. Remove Protective Cap
Figure 14. Connect Power Cable
2.
Grip the notched end of the floating power
cable, insert into the control box, and turn
clockwise to tighten. (Figure 14.)
NOTE:
To avoid damaging the power cable, do not try to
twist the entIre cable housing (see below).
NOTE:
To avoid exposing the power cable connector pins
to water, be sure the connector is screwed in all the
way and there is no gap. (see below).
Section 4. Operation
CAUTION
To prevent damage to the cleaner, be sure to adhere
to the following guidelines:
• Remove the cleaner from the pool after the
cleaning cycle is completed and store on the caddy
out of direct sunlight or inclement weather.
• For VX40 and VX45 4WD models where caddy
is not included in the pack, store the cleaner out
of direct sunlight or inclement weather. Store the
control box on the base as shown in Figure 12.
• Never lift the cleaner out of the pool by the floating
cable. Always use the lift feature to remove cleaner
from the pool.
• Take additional care when lifting the cleaner out of
the pool. It becomes heavier when filled with water.
• Always remove the cleaner from pool when super
chlorinating or adding acid.
• Do not handle cleaner while it is in operation.
IMPORTANT
• Always make sure the cleaner head is fully
submerged before you begin operation.
• Clean the filter canister after each cleaning cycle.
• Do not leave your cleaner in the pool on a
permanent basis.
• At the end of each cycle, remove the cleaner from
the pool. Start at the cleaner head and untangle any
coils in the cable before storing the cleaner.
H0516700_REV C
8
