• To remove the cleaner from the pool using the remote
control, press
(see Figure 23).
The cleaner rotates left until you release the Lift
System button.
4.8 Synchronizing the Remote Control
Even though the remote control is factory-synchronized
to your cleaner's control box, it may be necessary to
synchronize again if you need to replace either the
control box or the remote control.
• To synchronize the remote control to the control box:
Press
and hold for 3 seconds to turn on remote.
Plug the control box into a power source.
When the display shows the operating time, press
and
simultaneously for six (6) seconds.
• The display shows
followed by the
normal operating time display to indicate the cleaner
is now synched with the remote and ready to begin
operating in remote control mode.
4.9 Storing the Cleaner
The cleaner must be cleaned regularly using slightly
soapy clean water. Do not use solvents such as acetone
or its equivalent. Rinse the cleaner generously using
clean water. Do not let your cleaner dry in direct
sunlight near the pool.
NOTE:
For VX50 4WD and VX55 4WD models, it is
recommended that the cleaner is stored on its caddy
for drying (see Figure 26).
For VX40 and VX45 4WD models where caddy
is not included in the pack, store the cleaner out
of direct sunlight or inclement weather. Store
the control box on the base (see Figure 12).
1.
Disconnect the fl oating cable from the control
box. Replace the protective cap on the control
box.
2.
Starting at the cleaner head. Remove all coils
and tangles from the fl oating cable (Figure 25).
Figure 25. Untangle the Floating cable
3.
Loosely coil the fl oating cable starting at the
cleaner and moving toward the connection point
at control box.
Figure 26. Cleaner Correctly Stored on Caddy
13
H0516700_REV C
