![background image](http://html2.mh-extra.com/html/zodiac/iaqualink-z400iq/iaqualink-z400iq_instructions-for-installation-and-use-manual_3995888015.webp)
13
• The heat pump is on standby
• Press
for 2 seconds:
(software version vary depending on the appliances) is displayed for 4 seconds,
the last water temperature measured is then displayed
.
This value varies depending on the last temperature recorded during the last connection.
If no water flow was present during the last connection, the screen will display the value
.
•
Set the desired temperature (called the "temperature setpoint" ) (see § ‘’2.4.2 Adjusting the temperature setpoint’’).
After the start-up steps for your heat pump:
•
Shut down the water circulation temporarily (by stopping the filtration or closing valve B or C) to check that you
appliance stops after a few seconds (via the activation of the flow switch)
.
•
Reduce the setpoint temperature to below the water temperature to check that the heat pump stops operating.
•
Switch off the heat pump by pressing and holding
for 2 seconds and check that it stops
.
2.4 I User functions
2.4.1 Locking/unlocking the keyboard
To lock or to unlock the keypad,
press and hold
and
simultaneously for 3 seconds:
or
.
2.4.2 Adjusting the temperature setpoint
• Press
or
: the temperature setpoint is displayed and flashes,
• Press
to increase the temperature by 0.5 °C*,
• Press
to reduce the temperature by 0.5 °C**.
• Press
to confirm the desired setpoint temperature.
•
The settings screen is automatically exited after 3 seconds of inactivity on the keypad
or by pressing and releasing .
The heat pump stops automatically when the pool reaches the required temperature.
*Maximum setpoint temperature = 32 °C.
**Minimum setpoint temperature = 15 °C.
If the setpoint temperature has not been confirmed by pressing
, it will not be saved if the interface
returns to the home screen (which takes place automatically after 3 seconds of inactivity on the keypad or
by pressing and releasing
)
.
2.4.3 Activating/deactivating “silence” mode
«Silence» mode is used to reduce the noise level emitted by the heat pump.
The appliance will operate for a longer period of time with less power, however with a lower noise level.
There are 2 ways to activate the
“Silence”
mode:
1
st
method
• Press and release
, the symbol
will light up.
2
nd
method
• Press and hold
• Press
or
to display:
.
• Press and release
, the symbol
will light up.
•
The home screen automatically reappears after 60 seconds of inactivity on the keypad or by pressing and releasing
.
To deactivate the “Silence” mode, redo the manipulation, the symbol
will go out.
Summary of Contents for iAquaLink Z400iQ
