Never run high voltage and low voltage in the same
conduit.
1. Turn off all power to the power center.
2. Find a suitable place inside your home to mount the
iAquaLink 2.0 device.
3. Install the iAquaLink 2.0 device at least six (6) feet
(1.8 m) above the ground and at least five (5) feet
(1.5 m) away from other transceiver J-boxes.
NOTE
To improve performance of the iAquaLink
2.0 device, you may wait to permanently
mount it after it has been powered up. The
signal strength indicator shown during the
WiFi Hotspot method is a convenient way to
determine & optimize signal strength between
the iAquaLink device and the router.
4. Open the door to the power center and remove the
dead panel.
5. Pull cable through the knockout and into the low
voltage area. See Figure 4.
6. Strip back the insulation jacket of the cable
approximately 6" (15 cm).
7. Strip each wire ¼" (6 mm) and connect to the
red, wire connector on the power center PCB. A
multiplex kit (P/N 6584) may be required if there
are more than two (2) cables running to a red, wire
connector on the power center PCB.
4.3
Set Up the iAquaLink 2.0 Device for
Wireless Connection
There are 2 ways to do this, the Hotspot Method and the
WPS Method.
For wired connection skip to Section 4.5
Connect iAquaLink to the Home Network -
WiFi Hotspot Method
1. Remove the two (2) screws from the cover of the
iAquaLink 2.0 J-box. Remove the gasket and cover.
See Figure 5.
2. Inside the iAquaLink 2.0, toggle the WiFi - Wired
switch to clear the Wi-Fi settings and put the
iAquaLink in desired setup mode.
3. After clearing the WiFi settings and with the Wired/
WiFi switch set to WiFi, use a smartphone or WiFi
enabled device and go to WiFi settings. Connect
to the network labeled iAquaLink, followed by the
last three digits of the iAquaLink device number.
For example, iAquaLink ABC, if the last 3 digits of
the device were ABC.
4. Locate the device number on the side product label
or the door hanger that came with the device
5. Some devices will automatically re-direct you to
the Log In Screen. If not, open a browser and go to
any web page, such as zodiacpoolsystems.com
6. iAquaLink will display the networks it detects,
as well as signal strength. Select the network
iAquaLink should use.
NOTE
If prompted for a password, enter the password
for the home network (caps sensitive).
iAquaLink will disconnect from the smartphone
at this point.
7. Within 2 minutes, the yellow LED should turn
solid yellow, indicating it is communicating with
the router. When the green LED illuminates, the
iAquaLink is connected.
Connect iAquaLink to the Home Network -
WPS (WiFi Protected Setup) Method
1. Remove the two (2) screws from the cover of the
iAquaLink 2.0 J-box. Remove the gasket and cover.
See Figure 5.
2. Push the WPS Button on the pool owner’s router.
To find it, look for the symbol or see the
following notes.
Figure 4.
iAquaLink 2.0 J-Box Indoor Installation
Internet Service
Provider
iAquaLink 2.0
Device
Router
Computer
Wireless
or
Wired Connection
Red 4-Pin
Terminal Bar
Low
Voltage
Area
Internet
Page 9
iAquaLink™
2.0
Web Connect Device for AquaLink
®
Control Systems
|
Installation Manual
ENGLISH
Summary of Contents for iAquaLink 2.0
Page 2: ......