NOTE
Some brands use other names (like Quick
Setup) or other icons (such as padlock or
similar) for WPS. Some routers may have WPS
disabled, which may require using the hotspot
method.The hotspot method is recommended
for Apple routers
3. Inside the iAquaLink 2.0, toggle the WiFi - Wired
switch to clear the Wi-Fi settings and put the
iAquaLink in desired setup mode.
4. After clearing the WiFi settings and with the Wired/
WiFi switch set to WiFi, press and release the
WPS button on the iAquaLink and wait for the
small yellow LED, next to the WPS button to start
blinking slowly.
5. Within 2 minutes, the yellow LED should stop
blinking, and the green LED will illuminate. The
iAquaLink is now connected.
For additional assistance, contact our Technical Support
Department at 1-800-822-7933.
4.4
Set Up the iAquaLink 2.0 Device for
Wired Connection
NOTE
To prevent potential Ethernet signal
interference, order and install part
#
R0616800.
(Does not apply to wi-fi installations).
1. Remove the two (2) screws that secure the cover
and gasket on the iAquaLink 2.0 device. Remove
the gasket and cover. See Figure 5.
2. Slide the Wired/WiFi switch to the WIRED position.
3. To allow the cable to exit the device, use needle
nose pliers to remove the break-away piece. Wrap
the cable inside the J-box and route it through the
break-away hole.
4. Using an Ethernet (RJ45) cable connect the
iAquaLink 2.0 device to the homeowner's router.
5. Reinstall the cover and gasket on the iAquaLink 2.0
J-box with the two (2) screws previously removed.
4.5
Registering the iAquaLink 2.0
Device on the Web
To register, go to iAquaLink.com
You will need the following:
1. iAquaLink 2.0 Web Connect Device serial number
(found on the device, and door hanger)
2. Consumer's e-mail address (this will be the
account name)
3. Password (a unique password will be created)
4.6
LED Status Indicator Lights
Normal Operating Mode
Function
LED Indication
Power (Red)
ON = Power
OFF = No power
Network
Connection*
(Yellow)
ON = Connected to Network
Fast Flashing = Communication
Slow Flashing/OFF = Not connected
Online Status**
(Green)
ON = On-Line (connected to
internet)
OFF = Off-Line
* Network Connection: the connection between the
iAquaLink 2.0 device and the Wi-Fi access point
(ie. wireles router)
** Online Status: the connection to the internet. Only
possible when Yellow LED indicates the iAquaLink 2.0
is already connected or communicating to the router.
Figure 5.
iAquaLink 2.0 Device PCB Components
WPS LED
LED Status
Indicator Lights
iAquaLink PCB
Wired/WiFi
Selector
WPS Button
Ethernet / LAN
(RJ45)
Cover
Screws (2)
Gasket
Antenna
Hole for cabling
(Break-Away Piece)
Page 10
iAquaLink™
2.0
Web Connect Device for AquaLink
®
Control Systems
|
Installation Manual
ENGLISH
Summary of Contents for iAquaLink 2.0
Page 2: ......
