ZMC432N Motion Controller User Manual V1.5
The Ethernet port of the controller can be connected to a computer, HMI, etc. through
an Ethernet cable, and using point to point connection method. The schematic diagram
is as follows:
The controller can also be connected to the interchanger through an Ethernet cable,
and then use interchanger to connect to other devices, then multi-point connection can
be achieved. The schematic diagram is as follows:
3.9.
RTEX Bus Interface
ZMC432N motion controller has two 100M RTEX communication interfaces, and it
supports RTEX protocol. TX is send side, RX is receive side. RTEX bus is used to connect
Summary of Contents for ZMC432N
Page 1: ......
