XPCIE1028 Motion Control Card User Manual V1.0
⚫
For the public end, please connect the "EGND" port on the power supply to the "COM"
terminal of the external input device. If the signal area power supply of the external
device and the power supply of the controller are in the same power supply system,
this connection also can be omitted.
3.5.2.
Basic Usage Method
(1)
Please follow the above wiring instructions to wiring correctly.
(2)
After powered on, please connect to ZDevelop.
(3)
State values of corresponding input can be read directly through
“
IN
”
command or
through
“
ZDevelop/View/In
”
.
3.6.
OUT: Digital Output
Digital outputs are distributed in X300 and P700 signal interfaces.
3.6.1.
Digital Output Specification & Wiring
→
Specification
Item
High-speed output (OUT0-15)
Low-speed output (OUT16-31)
