24
Throttle servo mounted in tub. Make sure it’s on the correct side…
Both servos mounted. Shaft tube removed for clarity.
Glue these to the tub side.
Be sure that the servo is on the correct
side for the engine you are using, and
that the servo is not touching the tub
floor.
We like to use a nylon clevis on the
throttle end, and an EZ connector on the
servo end of the throttle. You may need
to use a small set screw instead of the
screw that comes with the EZ connector
to make it fit under the lid.
Remove the servos and pushrods.
Remove everything from the boat in
preparation for sealing.
