14
Radio box lid support glued in place behind bulkhead 2.
Foam nose block being test fit.
Foam sanded to match tub sides. Note angle sanded on aft sheeting.
Glue in the lid frame support. This gets
attached to the rear of bulkhead 2, and
is flush with the lower portion of the
sides.
Check the fit of the foam nose block. If
all is well, glue the foam nose block in
place with epoxy or poly glue. Allow to
cure.
Sand the foam flush with the tub sides.
Be careful not to sand the tub sides too
much.
This foam is needed for floatation, in
case you shear off both sponsons…