31
30
USER MANUAL
805846UK - ZIP HYDROTAP G4 V1.00 NOV 2017
TECHNICAL SUPPORT
TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UK
WWW.ZIPWATER.CO.UK
SECTION 11 HOME MENU ICONS
Safety switch is enabled.
The HydroTap
G4 will not dispense any Boiling water.
See tap sections for safety lock operation.
Safety switch is disabled.
Boiling water may be dispensed. See tap sections for safety lock
operation.
Sleep mode is active.
There are 7 sleep mode options which display this icon on the home
screen. See page 25
for details.
Heater is in off mode.
When this icon is displayed, no power is being supplied to the
heating element. See page 25 for Energy Mode options.
Filter use
This icon displays the filter usage remaining from 100% (new filter)
to 0% (end of life). When it reaches 0% the filter warning light on the
tap head will flash slowly. The filter life can be adjusted by litres and
by days used.
50%
Boiling temperature
The temperature of the water in the boiling tank will be displayed.
This is optimises at 98°C but may be adjusted between 68°C- 98°C.
See page 23 for hot set point adjustment.
Chilled temperature
The temperature of the water in the chilled tank will be displayed,
dependant upon model purchased.
SECTION 12 CLEANING
Do not use strong, corrosive spray or abrasive cleaners / chemicals.
Clean the casing, tapware, external filter, piping and all other fittings with a
soft cloth and mild soap and water.
Do not spray water over the tap as it may damage the low-voltage electronics.
Caution: Should any of the plastic fittings accidentally come into contact
with cleaners with a PH level less than 4, hypochlorite, hydrogen peroxide
or any other aggressive chemical the affected component must be replaced
immediately.
Command Centre units must never be located near, or cleaned with water
jets. Avoid using airborne pesticides near the Command Centre.
