17
Installation instructions & user manual
T210023 v1.02 NOV 2018 - ZIP AP430S-AP4100S
Technical support
Tel: 0345 6 005 005 email: service@zipindustries .co.uk www.zipwater.co.uk
Operation
• Once the maximum level is achieved, pressing the button returns the
temperature to the first setting .
•
We recommend the "eco" setting. This setting is the most energy-efficient. The
temperature of water is about 57 °C, while limescale production and heat loss will be
smaller than in case of higher temperature settings.
• When you last press the button, the setting is stored. After 5 seconds, the current
temperature in the tank is displayed on the display .
• If the heater will not be used for a longer period of time, please protect its contents from
freezing by setting the temperature to the position.
• At this setting, the heater will maintain the temperature of water at 10°C.
eco
2
eco
1
2
eco
Functioning of the heater in the Sma
rtEco
mode
•
This mode is appropriate especially if you have well-established hot water consumption
habits (e.g. showering every day at approximately the same time).
• To start the heater in the
Sma
rtEco mode, you first have to start recording. During the
recording time, the electronic regulator remembers your habits and takes them into
account while heating the water after the recording period has ended.
• The recording takes place for 7 days. The
Sma
rtEco mode reduces the consumption of
electrical energy.
• Pressing button will begin the recording of your habits.
•
The green control light will flash during the recording period.
• Once recording concludes after 7 days, the recording regime will begin running
automatically.
• The green control light will light up when the heater is functioning in the
Sma
rtEco mode.
• By pressing again, you can switch off the recording or the
Sma
rtEco function.
• The heater resumes to the basic mode of operation. The water is heated to the set
temperature.
• The
Sma
rtEco function can be resumed by pressing button .
• If the regime has already been recorded (if the recording was not interrupted), the regime
will begin running and the green control light will light up.
• If the recording was interrupted, a new 7 day recording period will begin and the green
control light will again begin flashing.
• If the electronic regulator has recorded the regime but the user's hot water consumption
habits have changed, a new recording period must be started. It can be started by holding
button .
• The recording period lasts 7 days.
4
3
4
4
3
3
4
