6
Installation instructions & user manual
T210023 v1.02 NOV 2018 - ZIP AP430S-AP4100S
Technical support
Tel: 0345 6 005 005 email: service@zipindustries .co.uk www.zipwater.co.uk
has been diagnosed and necessary repairs have been undertaken.
• Do not use the Aquapoint if it is suspected of being frozen. Switch off the
electrical
supply if water ceases to flow and do not switch on again until a
competent person has checked that it is safe to do so.
• The heater should be visually inspected regularly. This is particularly
important if its located in a cupboard, roof space or any other concealed
location. If there is any sign of leaks or seepage the Aquapoint should be
isolated from the water supply and switched off from the electrical supply
until a competent person has investigated the cause.
• Do not block or restrict the discharge from any safety valve.
• Do not tamper with any safety valve.
• The Aquapoint must not be subjected to pressure exceeding 6 bar.
• If water discharges from any safety valve switch off the electrical supply to
the Aquapoint, isolate the water supply and contact a competent person
familiar with unvented systems.
• Temperatures in excess of approximately 43°C are perceived as hot,
especially by children, and may cause a feeling of burning. Please consider
using the temperature controls.
• This Aquapoint must not be used by any person (inclu ding children) with
limited physical, sensorial or mental abilities or failing experience and/or
knowledge unless they are supervised by a person responsible for their
safety or have received instruction about how to use the Aquapoint, and
that are aware of the potential hazards.
• Children should be supervised in order to make sure that they do not play with,
use, clean or maintain the Aquapoint.
• In a closed, pressurised system of installation, it is obligatory to install a
safety valve on the inlet pipe with a rated pressure of 0.6 MPa (6 bar),
0.9 MPa (9 bar) or 1.0 MPa (10 bar) (see the label), which prevents the
elevation of pressure in the boiler by more than 0.1 MPa (1 bar) above the
rated pressure.
• Water may drip from the outlet opening of the safety valve, so the outlet
opening should be set to atmospheric pressure.
• The outlet of the safety valve should be installed facing downwards and in
a non-freezing area.
• To ensure proper functioning of the safety valve, the user should perform
regular inspection and maintenance to remove lime scale and make sure
SAFETY INFORMATION
