ZIMO MS450, Instruction Manual

Page: 56 / 88

Page 56 MS - SOUND decoders MS440 to MS990 and MN - NON-SOUND decoders MN170 to MN340
(acceleration, deceleration) should also have an in-
fluence on the sound due to the associated in-
crease or decrease in load.
= 0: No influence (sound depends on speed step
only)
= 64: experience has shown this to be a practical
value
= 255: maximum acceleration response
(Highest sound step during acceleration)
#388
Deceleration influence
On diesel sound steps
0 - 255 0
Same as CV #387 but used during decelerations.
= 0: No influence (sound depends on speed step
only)
= 64: experience has shown this to be a practical
value
= 255: maximum deceleration response
#389
Limited acceleration in-
fluence on diesel sound
steps
0 - 255 0
This CV determines how far the sound step may
deviate during acceleration from the simple speed
step dependence (= difference between target
speed from the controller and actual speed).
= 0: No deviation; motor sounds according to
schedule, sound does not depend on acceleration.
= 1 - 254: Dependence increases with value.
= 255: fully dependent on target speed.
#390
Momentum reduction
when driving solo (en-
gine only)
0 - 255 0
When switching to solo driving with key defined in
CV #347 the momentum reduction is activated
(with CV #348, Bit 1):
= 0 or 255: No reduction
= 128: Reduction to 50
%
= 64: Reduction to 25
%
= 1: virtually cancels all momentum.
#391
Driving with
idle sound, when driv-
ing solo
0 - 255 0
The diesel motor sound should remain at idle when
driving solo (with function key defined in CV #347),
until the speed step defined in CV #391 is reached.
#836 Motor Start Sound Bit 0 0
Bit 0 = 1: Loco shall not start driving before Start
Sound is fully played.
#378
Statistical probability
Of switchgear sparks
during
acceleration
in SW version 5.00 and
higher
0 - 255 0
Likelihood for sparks (as per CV #158 Bit 7 for FO7
or #394 for FO6) when accelerating
= 0: always
= 1: very rarely
= 255: very often (almost always)
#379
Statistical probability
of switchgear sparks
during
deceleration
in SW version 5.00 and
higher
0 - 255 0
Likelihood for sparks when decelerating (as per CV
#158 Bit 7 for FO7 or #394 for FO6)
= 0: always
= 1: very rarely
= 255: very often (almost always)
#364
Diesel engine with
Switchgear
Speed drop during
upshifts
In SW version 5.00
and higher
0
This special CV applies only to diesel-mechanical
engines and defines the
typical drop in speed when shifting up.
See sound projects (i.e. VT 61)
#365
Diesel engine with
Switchgear
Upshift rpm
In SW version 5.00
and higher
0
This special CV applies only to diesel-mechanical
engines and defines the
highest rpm before shifting up.
See sound projects (i.e. VT 61)
#366
Turbocharger
Maximum volume
0 - 255 48
#367
Minimum load for tur-
befor DIESEL engines
Turbo rpm dependency
on speed
0 - 255 150
Turbo playback frequency depending on engine
speed.
#368
Turbocharger
Turbo rpm dependency
on accelerationfor DIE-
SEL engines
Acceleration
0 - 255 100
Playback frequency depends on the difference of
set speed to actual speed (= acceleration).
#369
Turbocharger
Minimum load
0 - 255 30
Audibility threshold for turbochargers; the load is
derived from CV #367 and #368.
#370
Turbocharger
Frequency increase
0 - 255 25 Speed of frequency-increase of the turbocharger.
#371
Turbocharger
Frequency decrease
0 - 255 15 Speed of frequency-decrease of the turbocharger.
#289
Thyristor
Step-effect
0 - 255 = 1 - 255: Effect of pitch
#290
Thyristor sound pitch:
“slow” pitch increase
0 - 255 50 Sound pitch for speed defined in CV #292.
#291
Thyristor sound pitch:
Maximum pitch
0 - 255 Sound pitch at top speed.
#292
Thyristor sound pitch:
slow speed
0 - 255 Speed for sound pitch per CV #290.
#838
Thyristors Maximum
speed
0 - 255 255
Definition of the "maximum" speed level (1 - 255)
for which pitch applies according to CV #291.
#293
Thyristor sound pitch:
Steady volume
0 - 255 100
Thyristor sound volume at steady speed (no ac-
celeration or deceleration in progress).
#294
Thyristor sound pitch:
Volume at acceleration
0 - 255 200 Volume during acceleration
#295
Thyristor sound pitch:
Volume at deceleration
0 - 255 100 Volume during heavier decelerations (braking)
#357
Thyristor sound pitch:
Lowering
volume at
higher speed
0 - 255
Internal speed step at which the thyristor sound vol-
ume should be reduced. The volume stays at this
reduced level while braking.
By changing CV #158 Bit 6 = 1, the volume will be
raised while braking, nonetheless.
#358
Thyristor sound pitch:
Course of
Lowering volume at
higher speed
0 - 255
Defines a curve as to how the thyristor sound
should be lowered at the speed step defined in CV
#357.