54
ProBee-ZS10 User Guide Rev.1.1
7.2.2
S22
Description
Get/Set the timeout to permit joining. It determines the time in seconds that the device
will allow other devices to join to it when it starts network but an end-device cannot
perform it. If set to 255, the device will always permit joining.
Execute
ATS22?<CR>
ATS22=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default
60
Range
0 - 255
7.2.3
S23
Description
Get/Set the power boost mode of the adapter. If enabled, boost mode improves
sensitivity by 1dB and increases output power by 2dB, improving the link margin and
range.
Execute
ATS23?<CR>
ATS23=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default
0
Range
0 – 1
7.3
Data Transmissions
7.3.1
S31
Description
Get/Set the application-ACK mode. If it is enabled, a node retransmits data packet
when it is failed to send. A node sends next packet after receiving ACK from receiver
node. This value must be set the same on the source and destination node for data
transmission.
Execute
ATS31?<CR>
ATS31=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default
1
Range
0 - 1
7.3.2
S32
Description
Get/Set the transmission retries. If application-ACK is enabled, a sender tries to
retransmit up to this value.
Execute
ATS32?<CR>
ATS32=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default
5
