ZIEHL-ABEGG ZAS0, Operating Instruction

Page: 4 / 72

1 General information
1.1 Application
The drives are built according to the state of the art and recognised safety rules and are delivered safe
for operation. Unauthorised modi fi cations that impair the operating safety are not permitted. This also
applies to protective devices which are fi tted for touch protection.
The drives exclusive be used for the intended purpose and in a perfectly safe condition. The exclusive
intended purpose of the ZAS is for driving cable lifts. Any other use above and beyond this will be
considered as improper use. ZIEHL-ABEGG SE will not be liable for any damages resulting from this
or damage resulting from improper use. The intended use also includes observing all the instructions
in this manual and following the start-up instructions, the machine description and performing all the
necessary inspection and maintenance work.
1.2 Structure of the operating instructions
This manual is part of the drive and must always be kept in its vicinity for reference at all times. All
persons involved in mounting, operation, maintenance or repair of the drive must have read and
understood this manual. ZIEHL-ABEGG SE takes no responsibility for damage or disruption caused
by disregard of this manual.
1.3 Target group
The operating instructions address persons entrusted with planning, installation, commissioning and
maintenance and servicing and who have the corresponding quali fi cations and skills for their job.
1.4 Exclusion of liability
ZIEHL-ABEGG SE is not liable for damage due to misuse, improper use or as a consequence of
unauthorized repairs or modi fi cations.
1.5 Copyright
The copyright to this operation instructions is held by ZIEHL-ABEGG SE, K ü nzelsau. This operation
instructions must not be wholly or partly reproduced for competitive purposes, used in any unauthor-
ised way or made available to third parties without our agreement.
2 Safety instructions
2.1 General
ZIEHL-ABEGG SE electric motors are not ready-to-use products and may only be operated after
having been installed into machines or plants and established their safety, depending on the applica-
tion, by protective grating, barriers, constructive devices or other adequate measures (see also
DIN EN 294)!
Installation, connection to the power supply and commissioning may only be performed by quali fi ed
service personnel ! The relevant regulations must be observed!
Planners, manufacturers and operators of system parts or entire systems are responsible for the
correct and safe mounting and a reliable operation.
2.2 Pictographs
Safety instructions are highlighted with warning triangles and are depicted according to the degree of
hazard as follows.
Danger!
General hazardous area. Death or severe injury or signi fi cant property damage can occur if the
corresponding precautions are not taken!
Warning!
Middle or slight bodily harm is possible if the corresponding precautions are not taken!
2ULJLQDORSHUDWLQJLQVWUXFWLRQV
ZAS0 General information
A-TBA11_06-GB
Part.-No. 01008051-GB
4/72