ZIEHL-ABEGG ZAS0, Operating Instruction

Page: 10 / 72

4.3 Fastening the traction sheave
The drive will be delivered with the mounted traction sheave.
The traction sheave with conical hub sits directly on the main axle of the gearbox.
CAUTION!
Caution!
" It is not permitted to knock or hammer on the traction sheave because this could damage the
roller bearings, locking rings or shaft rings.
4.4 Fastening rope protection clamp
The drive is delivered with fi tted cable protection brackets (1) and cable protection supports.
Picture 4.4.1: Driving disk with front hand guard
1 Cable protection bracket
3 Cable protection support
Picture 4.4.2: Driving disk with rear hand guard
1 Cable protection bracket
2 Hex socket screw and hex nut
" Set these by swinging the cable protection brackets (1) so that the distance between the cable
and the cable protection bracket on the cable in and cable out side of the driving disk is as small
as possible (1 - 2 mm).
" Set fastening screws (2) and cable protection brackets (1) with a SW 13 open-ended wrench.
" In case of inclined pull, adjust the position of the cable protection brackets (1) to the changed
cable pull direction by suitable installation of the cable protection supports (3) on the gearbox
housing.
CAUTION!
Caution!
" For machines with cable direction of 0-90 ° over the horizontal (example: machine arrangement
bottom or top opposite), an additional cable protection is necessary which prevents penetration
of foreign bodies between the cable and the groove.
2ULJLQDORSHUDWLQJLQVWUXFWLRQV
ZAS0 Mechanical installation
A-TBA11_06-GB
Part.-No. 01008051-GB
10/72