After the successful ending of the installation, the system will inform
about the installation of a new device (g. 7.). Two new devices ap-
pear in the device manager –
Multi-transducer and Port COM named:
Multi-transducer , acc. to the g. 8.
Fig. 7. Systeme message ending the installation of Multi-transducer
After closing the creator, the system detect immediately the succes-
sive device – USB Serial Port (g. 6.). The creator for detection a new
hardware will start again.
Fig. 6. Systeme message concerning the detection of a new device
controllers
15
15
Summary of Contents for CON-M 22
