5.4.5 Setup of analog output parameters
After choosing the group:
output
1-4
, it is possible to congure following
output parameters:
a)
assignment of the parameter to the analog output. Kind of
signal, on which the output has to react acc. to the table 1,
b)
lower value of the input range. Percentage value of the
chosen signal,
c)
upper value of the input range. Percentage value of the
chosen signal,
d)
lower value of the output range. Output signal value in mA,
e)
upper value of the output range. Output signal value in mA,
f)
working mode of the analog output. Following modes are
accessible: normal work lower value, upper value. Both
alarms are set up in the normal mode by the manufacturer.
g)
value on the output by false input parameter value (1e20) in mA.
An exemplary conguration of the analog output is presented on the g.16.
Fig. 16. View of the analog output conguration window
25
25
Summary of Contents for CON-M 22
